A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
Our Long Lake, MN technicians locate the main or local shutoff valve immediately if it hasn't been closed already.
Pinpointing the break location prevents unnecessary demolition in the wrong section of wall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
Our Long Lake, MN team works alongside your plumber or one we can refer, so the repair and drying stay coordinated.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Long Lake, MN crews run it.
If the source is still running, shutoff is priority one.
Pressure testing and moisture tracing help pinpoint exactly where the line failed.
Water trapped inside the wall cavity gets extracted using specialized tools designed for tight spaces.
We remove only the insulation and drywall sections that moisture readings confirm are compromised.
Specialized drying equipment reaches into open wall cavities to dry framing and remaining materials.
Plumbing repair coordination is included so you're not managing two separate contractors.
We'll walk you through locating the shutoff valve over the phone if needed.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
You'll see the scope and cost once the failure point is confirmed.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
We handle the water damage mitigation and coordinate directly with a licensed plumber for the pipe repair itself.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Most burst pipe jobs dry out within about a week, similar to other structural drying timelines.
Long Lake sits within our core burst pipe response zone.
Call now and we'll help you locate the shutoff valve over the phone if needed.
Call +1-844-578-1604